First, the operation before entering the work area. Before entering the zone, the threshing clutch should be engaged smoothly to make the harvester run slowly. Then place the header, reel, etc. in the working position. Afterwards, a suitable gear is selected according to the crop condition, and finally the engine is placed at the rated speed and then the formal operation is started. The engine cannot be operated without reaching the rated speed to avoid clogging. Second, the operation when turning: Should turn up the header while turning the ground, and then still use the big throttle to keep the engine running at rated speed. In order to reduce the speed of advancement, the method of lowering gear is used to reduce the speed, but it is not possible to reduce the speed by using the method of reducing the throttle, otherwise it will cause failure or blockage to the conveying, threshing and other parts. Third, the operation of the windy days: the operation direction of the wind turbines harvesting operation unit should avoid the downwind movement; the air intake side of the cleaning mechanism on the windward side can be adjusted smaller, and the air inlet on the side of the leeward should be adjusted larger in order to balance. The amount of air flow reduces food losses and improves the quality of selection. Fourth, when the slope passes through the operation: in the transfer of the ground, the road transport, through the slope, must pass through the slope, avoid the cross slope through, so as not to lose the high stability of the lateral stability of the harvester overturned. If the slope is large, you should reverse the car up and downhill. V. Operation during car trapping: When you encounter a car trap, you must not attempt to cross it in the form of an out-of-the-way vehicle. Otherwise, the counter-productive action will be deeper and deeper, but you will not be able to get out of the trap. The correct way to deal with a car trap is to use a low throttle and a high speed, and use a low speed in the throttle. The wheels are riddled with stones, planks, sedges, etc. If there are shovels, the front of the trap can be dug. If one side is stuck in the car, you can use the differential to lock it, and open the differential lock immediately after it is out of the pit. When locked with a differential, the locomotive cannot be turned so as not to tip over, and it should remain in a straight line. VI. Operation in the wet section: In the harvesting of paddy fields with less muddy feet in the paddy field, additional ground protection nets (boards) may be added to increase the adhesion and prevent the cars from collapsing; when harvesting the muddy feet, the joint The harvester's walking device was changed to a half-track type and then returned to operation. VII. Operation of harvesting low crops: When rice blast grows low, the harvesting stage should strive to descend to the extent that it does not touch the ground. The reel should also be adjusted downwards and rearwards accordingly to prevent the attack on the ear of rice. It can increase the forward speed of the unit, thereby increasing the amount of feed, resulting in full-load feeding and improving work efficiency. Eighth, the operation of harvesting lodging crops: the unit forward direction and the crop fall in the opposite direction, or about 45 degrees with the lodging direction angle, in order to avoid missing cut. Move the reel wheel forward and down properly; reduce the cutter height so as not to touch the ground; reduce the forward speed and other measures to reduce the loss. 9. Operation of over-ripe rice: When the rice straw is over-ripened, it is easy to lose grain and increase loss during harvest. In order to avoid excessive losses, the following actions should be taken: Adding some strips on the saw blade of the reel can make the efforts to increase the buffer and the role of cracking the valley, thereby reducing the loss of grain. At the same time, it is necessary to reduce the height of the reel, so that the reel can avoid the location of the ear and reduce the impact spike. It is also necessary to appropriately reduce the reel speed so as to reduce the number of blows and reduce the probability of grain dropping. When harvesting easy-to-fly pellets, a collector should be installed under the harvester roller to recover the pellets and promptly remove them. 10. Points to be taken when transferring a lot (1) When entering the ground, pay attention to the field ridge. If the slope is large, the speed should be slowed down, and the slope should be diagonally reversed through the field ridge to buffer the slope; if the reaping platform is scratched At this time, it is not possible to forcefully pass it. It must be passed by Tian Hao. (2) For small field cranes, the locomotive can be selected to pass in a vertical direction with the field ridge. When the harvesting platform is close to the field ridge, the hydraulic lifting handle should be pulled up to raise the header position, so that the header is raised and then slowly moved forward; when harvesting After the table passes, it is lowered to its normal position. (3) After the current round passes the field hoe, the hydraulic handle should be immediately pushed to the descending position, so that the header is lowered, maintaining the normal distance between the header and the ground, the current round has passed the ridge, and at the same time, the reaping platform is raised again, still maintaining and The ground is at a normal distance. (4) When the rear wheels pass through the field, as the rear wheel rises, the liquid header is raised again, thereby avoiding the header to touch the ground and damage the cutter. When the rear wheel passes, the header is returned to normal. Note: Don't go straight through the field to save time and not to repeatedly lift the header, resulting in excessive bumps and damage to the cutting blade.
Human chorionic gonadotropin, is called HCG for short. It is a hormone widely used by bodybuilders to improve results when on anabolic steroid cycle . Different with steroids or SARMS which you can make finished gear from Raw Steroids , or semi-finished oils, HCG can be easily found as finished products status in vials or ampoule. The usage is similar to the Bodybuilding Peptides and Recombinant Human Growth Hormone, it needs to be mixed with sterile water or bacteriostatic water before injecting.
Human chorionic gonadotropin (HCG) is produced by the placenta of pregnant women and is very important for a healthy pregnancy process. Due to this point, there is a simple way to test the quality of the HCG .That is to use a Pregnancy Test Kit. It`s very easy but effective method. Everyone can do it easily if has any doubt on the quality of the HCG.
Why is HCG widely used by professional bodybuilders ? One of the main effects of HCG is as a diet aid. The HCG diet becomes popular in western medicine. It`s often comprised of a total caloric intake, about 500 calories per day. A lot of physicians have proved the success of the HCG diet.
The effects of HCG on the anabolic steroid users can be two different ways, first PCT use and ,second, on cycle use.
Almost all anabolic steroids users`nature testosterone production is low. No matter what steroids ,( 1453042,testosterone , trenbolone , or other steroids ) are being used the nature testosterone production would be lower than the normal standard. The rate of the influences depends on the total dosage of the anabolic steroids being used. Once the anabolic steroid cycle stopped or ended, most steroid users will implement a PCT plan in order to enhance recovery.
HCG use during anabolic steroid cycle is to prevent permanent shutdown of testosterone production. Normally a low dose of human chorionic gonadotropin HCG, 250iu per time, two to three times a week can be used during the steroid cycle. But still need to be very careful and avoid dosing too high or too frequently. HCG is one of the most side effect friendly hormones. Side effects similar to the traditional medicines such as headaches, rashes or other related issues are possible. In general, HCG can be used both as PCT after steroid cycle , and also during steroid cycle.
Here comes the last question, where to buy HCG ? You can easily buy HCG online, or from anabolic steroid suppliers. Most steroid suppliers including the raws steroid supplier offer it,too . Ordering online is very simple and also affordable compare besides you can easily get it with no description. As a raw supplier in from China, we can offer not only good quality steroid raws, Human Growth Hormone, peptides and SARMS, but also HCG. It`s definitely good quality products and come with sterile water kits ,too. It`s 5000iu per vial, 10 vials per kit. And also price is very reasonable. Don`t hesitate to ask our sales rep about it.
Recombinant Human Growth Hormone
Recombinant Human Growth Hormone,Growth Hormone Injection,Original Jintropin,Growth Hormone
beststeroidraws Co., Ltd , http://www.beststeroidraws.com