1. On-site installation and no-load test operation: After completing on-site installation and commissioning, then carry out on-site no-load test operation for not less than two hours.
2. Load test operation:
(1) Excluding all unsafe factors and then carrying out the load test operation;
(2) Loading materials (loaded by small and medium-sized materials first);
(3) below the machine linkage (crusher);
(4) When starting the test run, it should be controlled within a lower operating speed range.
3, test running performance:
(1) inspection of material carrying and discharging conditions; (block determination);
(2) Whether the conveyor is deflected or interfered with by the interference card;
(3) Whether the current value of the load operation is qualified;
(4) Whether the roller and return roller are running normally;
(5) The heat of each bearing part is especially important.
4. Industrial operation:
(1) Excluding the abnormal condition of the load test operation;
(2) Check the bolts at all parts and tighten them sufficiently (stepwise tightening during operation);
(3) Adjust the tension of each side traction chain (control pre-tension);
(4) The roller adjustment, the deviation adjustment, the transmission adjustment, after handling all the abnormal conditions, can be transferred to the normal industrial operation.
5, fault handling: start and run, such as the occurrence of abnormalities and signs of failure, should immediately stop the inspection, identify the reasons, eliminate hidden dangers. Do not restart before unhandled, please be sure to pay full attention and attention!
Most people will have already given a urine sample at some point in their lives. A sample can be analyzed using a number of different tests. These tests can help doctors diagnose certain diseases or to monitor their progress. For example, Urine Test Strips can show whether you may have a urinary tract infection or diabetes.
A rapid Urine Test is the quickest way to test urine. This involves dipping a test strip with small square colored fields on it into the urine sample for a few seconds. After that you have to wait a little for the result to appear. Depending on the concentration of the particular substance you are testing for, the fields on the test strip change color. Then the resulting colors of the fields are compared with a color table. The color table can be found on the urine test package. It shows which colors indicate normal and abnormal values.
Urine Test Strips
Urine Test Strips,Urine Test Strips For Diabetic,Urine Strip 10 Parameter,Urine Testing Equipments
Changchun Medicon Technology Development Co., Ltd , http://www.jlmdk.com