1. The ice crusher should be installed on a workbench with sufficient supporting force and at an appropriate distance from the ground.
2. Before turning on the power, first check the power supply voltage used, whether it matches the voltage used by the machine, whether the socket meets the safety standard, and install the leakage protection switch and ground wire. Confirm that everything meets the requirements for electricity use.
3, before starting, first break the ice to a diameter of about 20 mm, in order to put into the barrel, the upper side is convex over the barrel mouth is appropriate. Note that the power switch is turned on first, and the handle of the platen pressing cover is allowed to be pressed down after the motor is rotated by the power disk. At this time, the ice cube is chopped by tightening the blade on the rotary cutter head. However, when the handle of the presser cover is pressed down, the force should not be excessively forced to prevent the motor from being blocked and the motor being damaged. And should pay attention to the amount of ice after the reduction, and timely add new ice blocks.
4. The chopped ice particles flow into the tray through the discharge port. It should be noted that the discharge of the discharge port is smooth and cannot be blocked. Otherwise, the cutter will be stuck and the motor will be burned out. If the cutter disc is found to be stuck, immediately lift the handle of the press cover, close the switch, unplug the plug, and eliminate the fault in time.
5. The thickness of the ice particles can be achieved by adjusting the height of the blade to protrude from the blade. When adjusting, first remove the plastic disk of the protection switch device, loosen the screw that fixes the elbow, pull out the barrel, and then release. For the fastening screw of the cutter head, remove the cutter head, and then loosen the compression screw of the insert. According to your requirements, install it in place, and then put the cutter head and the like back in order.
Precautions
1. To ensure safety, it is not allowed to directly press the ice block for cutting.
2. After each use, it must be cleaned. When cleaning, turn off the main power switch, unplug the plug, and then wipe the water on the machine with a clean towel. After cleaning, remember to lift the handle of the press cover.
3. Do not use detergent when cleaning to prevent contamination caused by detergent left on the machine. It is also not possible to rinse directly with water to prevent the electrical components from getting wet, which may affect the safe use and damage to the unit.
4. The temporary design rate of the motor design of this machine is 80%, and it is necessary to avoid long-term continuous operation. After one hour of continuous work, you should pause for twenty minutes before starting work. This will greatly extend the life of the motor.
5. Whether it is cleaning, repairing, replacing the blade or cleaning the ice residue, etc., the power should be turned off first, and the power plug should be unplugged; the machine is not allowed to run for a long time without load.
Massage Chair,Massage Recliners ,Shiatsu Massage Chair ,Portable Massage Chair
Massage Chair,Handheld Massager Co., Ltd. , http://www.nbmassagechair.com